热re99久久国产精品_国产成人精品免费大全_欧洲日韩视频二区在线_欧美在线一区二区三区_99在线视频精品费观看视_99久久这里只精品国产免费_亚洲欧美韩国日产综合在线_伊人色综合久久天天人守人婷_99热精品在线免费观看

中文版

News
Control Cabinet Cable Layout Rules

The signal line

The cable direction should be horizontal and vertical, and the cold pressing head (also known as the pin) must be pressed on both ends;

When turning the cable, avoid dead bending and it is best to be smooth. This avoids damage to the outer skin and internal copper core of the cable.

The wiring of the equipment on the front door panel is all connected with flexible wires to prevent wire breakage;

Wrap the wires that are not in the slot with wrapping pipes to ensure that only the markings and joint parts can be seen from the outside;

Signal and cable lines should be avoided from overlapping as much as possible to avoid interference.

Short wiring

The length of short wires with equal spacing should be consistent, preferably connected by a single wire;

The height and isolation of the same short circuit should be consistent;

If there is only one short wire on the wiring terminal, press on the cold pressed terminal;

power cord

When the positive pole of the power supply is marked with "+" on the DC output and module of the power supply, a red cable is used. When the positive pole is marked with "-" or "GND", a black cable is used, and other colored cables, such as blue or yellow, are used for the signal wire.

For AC power wiring, red or brown wire is used for "L", blue or black wire is used for "N", and yellow or green or chartreuse wire is used for "G".

© Yueqing Xingxuan Electric Technology Co., Ltd   浙ICP備13007669號